Build Tap Kit by ThunderCloud

Build Tap Kit by ThunderCloud – 2-in-1 Ohm Meter & Coil Tester

• Independent Work Platform for DIY Building
• 2-in-1 Resistance Testing and Coil Firing
• Standard Spring-Loaded 510 Connector
• Powered by a Rechargeable 18650 Battery
• Portable All-in-One Kit with Storage Case and Coils
  
• Multiple Circuit Protections

Check your resistance. Test fire your build. Do it all from one compact 510 tool — because guessing your ohms isn’t a strategy, it’s a hazard.

The Thunder Cloud Build Tap Kit is a digital resistance tester and coil-firing platform designed specifically for rebuildable atomizers and DIY coil users. It integrates resistance reading, coil firing, and coil adjustment into one device, allowing users to perform essential testing and setup before putting a coil into regular use.

To use the device, first connect the atomizer or build deck with the coil installed to the top 510 connector. Switch the device to Meter Mode, and the screen will display the current resistance. Once the resistance is confirmed to be within a suitable range and remains stable, switch to Fire Mode and briefly press the fire button to pulse-heat the coil.

During heating, check whether the coil glows evenly from the center toward both ends. If any hot spots, uneven heating, or one-sided overheating occur, release the fire button and use an appropriate tool to adjust the coil. Then measure the resistance again and repeat the short firing process.

The device is powered by a single rechargeable 18650 battery (not included) and features a Micro USB charging port, making it suitable for everyday DIY building, coil installation in vape shops, and atomizer maintenance. Its digital display and independent mode switch make the resistance-testing, coil-firing, and power-off states easy to identify.

The Build Tap Kit is not intended to replace a professional high-precision multimeter. Instead, it provides a more direct, convenient, and purpose-built platform for atomizer coil building and adjustment.

Product Specifications:
1 x Build Tap (80mm×60mm×23mm)
2 x Ni80 2-Core Clapton Coil-26gax2+38gaxID3.0x0.28Ω
1 x Storage Case (110×75×30mm)

Every serious builder knows the rule: never fire a coil you haven’t checked. The ThunderCloud Build Tap Kit takes that rule and makes it effortless — a 2-in-1 digital ohm meter and test-fire station built for anyone who wraps their own wire and refuses to skip a safety step.

Drop your atomizer onto the spring-loaded 510 connector and flip between two modes: Meter Mode reads your exact resistance in seconds, while Fire Mode lets you dry-burn the coil to even out hot spots and clear leftover debris before it ever touches your mod. Whether you’re running an unregulated mech mod where an unchecked ohm reading is a real risk, or you’re simply dialing in a fresh Clapton build on your RTA, this is the check you do first — every time.

We didn’t stop at the tool. Every kit ships with 2 premium Ni80 dual-core Fused Clapton coils pre-included, so you can test the kit itself the moment it lands, no separate coil purchase required.

Compact, precise, and built to pair with the entire ThunderCloud RBA and RTA lineup — including the iDot RBA — the Build Tap Kit is the difference between building blind and building like a pro.

Know your ohms. Trust your fire. Build with confidence.